3-8
The Loop/Auto Shuttle dialog box contains three additional settings that
affect the details of how looping operates:
With the default option settings, Pro Audio will play the loop over and
over again, continuously. You can stop and resume playback at any point
during the loop.
If you start playback before the loop start time, Pro Audio will play until
the loop end time is reached, then jump back to the loop start time. If
you start playback after the loop end time, the loop is ignored.
The Rewind command operates slightly differently when looping is in
effect. The Þrst time you rewind, the Now time is set to the start of the
loop. If the Now time is already at the start of the loop, Rewind takes you
to the beginning of the project. From then on, Rewind switches back and
forth between the loop start time and the start of measure 1.
Option... How it works...
Rewind to start time on stop Whenever you stop playback for any
reason, Pro Audio rewinds immediately
to the start of the loop (this option is off
by default)
Stop at the end time Playback does not proceed beyond the
end of the loop
Loop continuously When playback reaches the end of the
loop and rewinds to the start, playback
continues automatically (this option is on
by default)
To Next Page
Loading...