3-9
Playback
To Set Up a Playback Loop…
1. Set the loop start and end times in one of the following ways:
• Drag the mouse between two points in the time ruler of the
Track, Piano Roll, Staff, or Audio view to select a range of
times, then click in the Loop/Auto Shuttle toolbar to copy
the selection time to the loop time
• Click between two markers in the Track, Piano Roll, Staff, or
Audio view to select a range of times, then click in the
Loop/Auto Shuttle toolbar to copy the selection time to the
loop time
• Type the loop start and end times directly into the toolbar
• Select a range of times, then right-click in the time ruler and
choose
Set Loop Points
(this method makes step 2
unnecessary)
2. Click to turn looping on.
To Change the Loop Settings…
1. Click , or choose
Realtime-Loop and Auto Shuttle
to display
the Loop/Auto Shuttle dialog box.
2. Check the options you want to use.
3. Click OK.
To Cancel a Playback Loop…
1. Click on the toolbar to disable looping.
To Next Page
Loading...