~te,aWQiil~ajl<t,k"y,gfii'ieC,Q,~~Qf,,;MQYrJJllQ=Y"'C"'~C_o;~~",3;))J71~:F22i:;YJtht_wJ~~,JS
You
can create a backup copy
of
your finalized disc on a common (12 cm) DVD disc.
Even
if
your computer does not have a DVD drive with writing capabilities, you can use
the camcorder itself to create a backup disc on an 8 cm Mini DVD disc.
1. Connect
the
camcorder
to
the
computer
and run MyDVD
for
Canon as
previously
described
(CD
106).
2.
Insert a finalized
disc
in the camcorder and load a brand
new
media in
your
computer's
DVD drive.
o
To
make a copy
of
a DVD-RW recorded
in
VR
mode, load a blank DVD-RW
in
your
computer's DVD drive.
To
make a copy
of
a DVD-R
or
DVD-RW recorded
in
VIDEO
mode, you can load a blank DVD-R or DVD-RW.
o
You
can also use a fully erased DVD-RW disc instead
of
a brand new media.
However, depending on the condition
of
the disc, the operation will take longer.
To
fully erase a DVD-RW disc you will need DVD authoring/mastering software (for
example Roxio Record Now!) installed in your computer.
3.
Click
on
the "Make a Backup DVD"
option
in the New Project tab.
4. Select the
camcorder
as the "Device
to
read
from".
5.
Select the
computer's
DVD drive (with
writing
capabilities) as
the
"Device
to
write
to".
If your computer is not equipped with a DVD drive with writing capabilities, select the
camcorder also as the "Device to write to".
6.
Click
on the
"Copy"
button
and
follow
the
indications
on
the
screen.
o When the "Your disc was created successfully" screen appears, click on "OK" to
finish the task and eject the backup disc.
o When the "Please insert a blank or rewritable DVD into the DVD drive" dialog box
appears, if the tray
of
a DVD drive other than the one selected
in
step 5 is ejected,
click on "Cancel" and start again from step 4.
If
this problem occurs,
if
the source
disc is a DVD-RW disc, some recordings on the source disc might be lost.
108
D
o
If
you create a backup copy
of
a disc containing only still images, the backup
copy cannot be read with the camcorder.
o Recordings made
in
LP mode
in
Widescreen (16:9 aspect ratio) on a DVD-RW
that was initialized
in
VR mode cannot be transferred to the computer.
o We recommend powering the camcorder from a household power outlet while it
is connected to the computer.
o The time required to complete the backup copy will vary depending on the
scene recording conditions and the amount
of
free space remaining on the
source disc.
o Finalized DVD discs created with MyDVD for Canon cannot be unfinalized
using the camcorder.
o For further details about restrictions when using MyDVD for Canon, refer also to
the "README" section
in
the software's help modules.
To Next Page
Loading...
