I
Installing
the Digital Video Software
o Be sure to install the Digital Video Software before connecting the
camcorder to the computer.
o Users
of
Windows 2000 or Windows XP must first log
in
as
an
Administrator
to install programs.
Windows XP
Users:
Your digital video camcorder is equipped with the standard Picture Transfer
Protocol (PTP). This protocol enables you to download still images by simply
connecting the camcorder to a computer with the USB cable (the software such
as the [Scanner and Camera Wizard] starts automatically).
However, please note that there are several limitations to downloading still
images with this method.
To
avoid these problems, install ZoomBrowser
EX
to
download still images.
- It may take a few minutes, after connecting the camcorder, until you can
download still images.
- Still images protected
on
the camcorder may lose this setting once they are
downloaded to the computer.
1 Check a camcorder
is
not connected to the computer.
While a camcorder
is
connected to the computer, the software cannot be
installed normally. If a camcorder is connected, detach the USB cable from the
computer.
2 Close any programs that are running.
3 Set the DIGITAL VIDEO SOLUTION DISK
in
the computer's
CD-ROM drive.
Ifthe installer panel does not open automatically, use the following procedures
to display it.
- Windows 98/Windows Me/Windows 2000:
1)
Double-click
the
[My
Computer]
icon.
2) Right-click the CD-ROM icon and select [Open] from the displayed
menu.
3) Double-click the [SETUP.exe] icon.
- Windows XP:
1)
Select
[My
Computer]
from
the
[start}
menu.
2) Right-click the CD-ROM icon and select [Open] from the displayed
menu.
3) Double-click the [SETUP.exe] icon.
Depending on the setting
of
your computer, the file extension U .exe" may not
appear.
4 Select your language.
E
To Next Page
Loading...
