124
Problem
Solution
OJ
The disc cannot be ejected.
Turn off the camcorder, disconnect the compact power
-
adapter and remove the battery pack. Restore the power
supply and try again.
The camcorder has exceeded it operational temperature.
Disconnect the compact power adapter and remove the
battery pack and let the camcorder cool down before resuming
use.
The camcorder vibrates.
Depending on the condition
of
the disc, the camcorder might
-
vibrate occasionally. This is not a malfunction.
The disc's rotation can be The disc is activated from time to time. This is not a
-
faintly heard.
malfunction.
Occasionally the operation
The disc is activated from time to time. This is not a
-
sound can be heard.
malfunction.
After using the camcorder for
This is not a malfunction. Turn the camcorder off and let it cool
-
a long time the
~
lights up
for a while before resuming operation.
in
red.
Recording/Editing
Problem
Solution
OJ
"~
"flashes red on the screen. The camcorder malfunctions. Consult a Canon Service
-
Center.
Image will not appear
on
the Set the camcorder to
ICAMERA·-"I.
33
screen.
Open the lens cover.
"SET THE TIME ZONE,
Set the time zone, date and time.
28
DATE AND TIME" appears
on
Recharge the built-in lithium battery and set the time zone,
134
the screen.
date and time.
Pressing the start/stop button
Set the camcorder to
ICAMERA·
_"
l .
33
will not start recording.
Load a disc.
31
The disc is full
("
® END" flashes on the screen). Delete some
31
recordings (DVD-RW in VR mode) to free some space
or
87
replace the disc.
Disc is protected. Cancel the disc protection
or
replace the
90
disc.
The camcorder has exceeded it operational temperature.
-
Disconnect the compact power adapter and remove the
battery pack and let the camcorder cool down before resuming
use.
Even after stopping recording, The scene
or
still image is being recorded on the disc. 33
the disc access indicator does 35
not go off.
The point where the start/stop There is a slight interval between pressing the start/stop
-
button was pressed does not
button and the actual start
of
the recording on the disc. This is
match the beginning/end
of
not a malfunction.
the recording.
The recording suddenly stops The disc is dirty. Clean the disc with a soft lens-cleaning cloth
-
shortly after
star1!ng
or replace the disc.
recording.
The camcorder has exceeded it operational temperature.
Disconnect the compact power adapter and remove the
battery pack and let the camcorder cool down before resuming
use.
Camcorder will not focus. Autofocus does not work
on
that subject. Focus manually. 52
Adjust the viewfinder with the dioptric adjustment lever. 24
Lens is dirty. Clean the lens.
137
To Next Page
