73
C Creative Auto Shooting
(2) Extra Effect Shot
• You can select any of the following effects before shooting: Creative
filters (p.128), Picture Styles (p.106), and Ambience-based shots (p.87).
•Select [c: Enable], then tap [2].
•Tap [e] and [f] to select a shooting effect.
• When you take a picture, two images will be recorded. One with the
effect applied and one without. Immediately after you take a picture, both
images will be displayed together. The image without the effect is
displayed on the left and the one with the effect will be on the right.
* If you are using an Eye-Fi card and have set it to erase images after their
transfer, the image without the effect will not be displayed during the playback
immediately after shooting.
Registering your favorite shooting effects
• During the image review immediately after shooting and during
playback, the image applied with the effect will have the [d] icon. You
can check which shooting effect was applied by tapping the icon.
• You can register up to two shooting effects under [9: Favorite effect].
• When you select the registered [9: Favorite effect], you can shoot with
that shooting effect applied. You can also overwrite the [9: Favorite
effect].
(3) Attached Speedlite 90EX flash firing
[a] Auto flash : The flash fires automatically when necessary.
[I] Flash on : The flash fires at all times.
[b] Flash off : The flash is disabled.
* When a flash other than the Speedlite 90EX is attached, the flash mode will be
set to Flash on.
You cannot set Extra Effect Shot and Ambience-based shots, or Extra Effect
Shot and Background blur, at the same time.
To Next Page
Loading...
