Canon MF726Cdw - FAX

FAX
Lis of SSSW
SSSW No. Bit No. Function
SW 01 (Switch relating to error and copy)
Bit 0 Output of error code for service technician
Bit 1 Error memory dump
SW 02 (Switch relating to settings for network connection condition)
Bit 7 Connect the terminal as F network type 2
SW 03 (Switch relating to echo prevention)
Bit 0 TCF EQM check
Bit 7 Output 1080Hz before CED
SW 04 (Switch relating to prevention of communication problems)
Bit 1 Frequency check of CI signal
Bit 3 Prohibit T.30 node F kept by both parties
Bit 4 T.30 node F echo timer
Bit 5 Frequency check of CI signal at PBX settings
Bit 6 No CNG transmission at the time of manual transmission
Bit 7 No CED transmission at the time of manual transmission
SW 05 (Switch relating to standard functions and DIS signal settings)
Bit 2 mm/inch conversion (text/photo mode / photo mode)
Bit 3 Prohibition of bit transmission after DIS bit 33
Bit 4 Declaration of cut paper
SW 06 (Switch relating to settings for reading condition)
Bit 4 Scan width 0: A4, 1: LTR
SW 07 to
11
Not in use
SW 12 (Switch relating to settings for page timer)
Bit 0 Timeout period for 1 page (transmission)
Bit 1 Timeout period for 1 page (transmission)
Bit 2 Timeout period for 1 page (Halftone transmission)
Bit 3 Timeout period for 1 page (Halftone transmission)
Bit 4 Timeout period for 1 page (Reception)
Bit 5 Timeout period for 1 page (Reception)
Bit 7 Timeout period for 1 page
SW 13 Bit 2 Execution of mm/inch conversion when sending the received image
SW 14 Bit 2 Setting whether to execute inch to mm conversion in horizontal and vertical scanning directions or in vertical
scanning direction only
Bit 4 Declaration of inch-configuration resolution
SW 16 Not in use
SW 17 Bit 1 Range of selection of transmission level of modem (0 : 8 to 15, 1 : 0 to 15)
SW 18 Bit 0 Detection of carrier disconnection between DCS and TCF
Bit 1 Time to wait for carrier disconnection between DCS and TCF
Bit 2 Prohibition of communication control for IP network
SW 19 to
21
Not in use
SW 22 Bit 3 Prohibition of manual polling operation
SW 23 to
24
Not in use
SW 25 (Setting for report display function)
Bit 0 Prioritize the received abbreviated name to the dialed
abbreviated name
SW 26 to
27
Not in use
8. Service Mode
302