Canon MF726Cdw - Setting of NCU Parameters

Numeric parameter setting mode
No. Parameter Allowable setting range
07 Spare
08 STORED_DIAL_MODE wait timer 0 to 65 sec
09 Not in use
10 T.30 T0 timer 55 sec principally
11 T.30 T1 timer (for incoming transmission) 0 to 9999 (France: 3500, Others: 3000)
12 Maximum incoming lines 0 to 65535 (line)0: without limitation
13 T.30 EOL timer 500 to 3000 (set to 55 sec by default)
14 Not in use
15 Threshold between hokking nad on-hook 0 to 999
16 Lead time to the first response when switching between FAX and TEL 0 to 9
17 Duration to activate pseudo-RBT cadence 0 to 999
18 Duration to deactivate pseudo-RBT cadence (short) 0 to 999
19 Duration to deactivate pseudo-RBT cadence (long) 0 to 999
20 Duration to activate pseudo-ring cadence 0 to 999
21 Duration to deactivate OFF Hook cadence (short) 0 to 999
22 Duration to deactivate OFF Hook cadence (long) 0 to 7
23 to 24 Not in use
25 CNG monitor duration while the answering device is activated 0 to 999
26 to 28 Not in use
29 Off-hook PCB duty settings(For NAC, setting can be made with SPL71100
in special management mode.)
20 (*10ms)
30 to 48 Not in use
49 NSX MODEL ID 0 to 4095
50 Not in use
51 Threshold to detect hook 10 to 9999
52 Not in use
53 Set DTMF calling counts when receiving FAX remotely 10 to 9999 (default 25)
54 Set Busy Tone outgoing duration when using handset
55 to 80 Not in use
Setting of NCU Parameters
■ TONE/PULSE
Operation Method
1. Setting of Tone Parameters
Operate as follows, and change to the parameter setting mode.
1. While "#NCU" is displayed, press "OK" key
2. Press "#TONE" key
3. Press "OK" key
2. Setting of Pulse Parameters
Operate as follows, and change to the pulse setting mode.
1. While "#NCU" is displayed, press "OK" key
2. Press "#PULSE" key
3. press "OK" key
Item Function Setting range
TONE 01; Tone signal sending time (PSTN) 10 to 9999 (msec)
02; Minimum pause time (PSTN) 10 to 9999 (msec)
PULSE PULSE FORM Pulse digit format 0 to DP ( N )
1 to DP ( N+1 )
2 to DP ( 10-N )
PULSE NUM 01; Not in use
02; Not in use
03; Pulse dial make ratio 10 to 90 (%)
8. Service Mode
304