Canon MF726Cdw - Fax

TESTMODE > PRINT
Item Description
Display/adj/set range 0 to 1
0 : Normal gamma LUT
1 : Through (linear) gamma LUT
Default value 0
Supplement/memo Gamma LUT: Density gradation characteristic table
NRKE
Title ON/OFF of laser scanning transfer process of test print
Details To perform line transfer process for skew correction of test print engine's laser scanning.
Use case At trouble analysis
Adj/set/operate method Enter the setting value, and then press Apply key.
Display/adj/set range 0 to 1
0 : OFF
1 : ON
Default value 0
Supplement/memo Transfer process: A process to correct skew of laser scanning toward vertical scanning direction
BLND
Title ON/OFF of interpolation process at test print
Details To set ON/OFF of interpolation process at test print (linked with NSC).
When 1 is set, interpolation process is performed (no phase shift).
Use case At trouble analysis
Adj/set/operate method Enter the setting value, and then press Apply key.
Display/adj/set range 0 to 1
0 : OFF
1 : ON
Default value 0
Supplement/memo Interpolation process: A process to predict, for pixels holding no color information, color based on
the surrounding pixels, and then set up the color information.
FEED
Title Setting of paper source at test print
Details To set the paper source at the time of test print output.
If this mode is set when there is no Cassette 2 (option Pickup Cassette), the output is made from
Cassette 1 (standard Pickup Cassette).
Use case At trouble analysis
Adj/set/operate method Enter the setting value, and then press Apply key.
Display/adj/set range 0 to 4
0 : MP Tray
1 : Cassette1
2 : Cassette2
3 : Cassette3
4 : Cassette4
Default value 1
START
Title Output of test print
Details To output a test print with the PG pattern set in PG-TYPE, MODE, etc.
Use case At trouble analysis
Adj/set/operate method Press Apply key.
Display/adj/set range 0 to 1
Default value 0
FAX
■ MODEM
FAX model only
8. Service Mode
309