Canon MF726Cdw - Removing the Patch Density and Registration Sensor Unit

CAUTION:
Be sure to install the harness [1] to the guide [A] of the
ITB Unit when installing.
[1] [A]
1x
Removing the Patch Density
and Registration Sensor unit
■ Preparation
1. Removing the Right Cover.(Refer to “Removing the
Right Cover” on page 120 )
2. Removing the Left Cover.(Refer to “Removing the
Left Cover” on page 118 )
3. Removing the Rear Upper Cover.(Refer to
“Removing the Rear Upper Cover” on page 123 )
4. Removing the ADF Unit + Reader Unit.(Refer to
“Removing the ADF Unit + Reader Unit” on page
130)
5. Removing the Right Front Cover.(Refer to
“Removing the Right Front Cover” on page 121)
6. Removing the Upper Cover.(Refer to “Removing the
Upper Cover” on page 125 )
7. Removing the High Voltage Power Supply PCB.
(Refer to “Removing the High Voltage Power Supply
PCB” on page 163)
8. Removing the Cartridge Tray.(Refer to “Removing
the Cartridge Tray” on page 127 )
■ Procedure
CAUTION:
Be sure not to touch the surface of the ITB and the
Secondary Transfer Roller when disassembling/
assembling.
1. Remove 1 connector [1], and remove the wire
harness [2] from the wire harness guide [3].
• 8 fixing guides [4]
[1]
[2]
[2]
[4]
[4]
[3]
5x
3x
1x
4. Disassembly/Assembly
193