Ceia THS - Guide to the Applicable Installation Operations; General Guidelines for Mechanical Installation

THS – FI022GB2K8v3 --- V - MAINTENANCE
16
Guide to the applicable installation operations
Operation Section / Paragraph to read
CEIA integrated system with
conveyor belt
Non-integrated THS system, without
conveyor belt
Unpacking the device and
checking that the various
components of the system are all
there.
_
Reading the installation
instructions
INSTALLATION SECTION
• General guidelines for mechanical
installation
• General guidelines for electrical
installation
• Installation of a CEIA THS integrated
system with conveyor belt
• Electrical installation - General notes
INSTALLATION SECTION
• General guidelines for mechanical
installation
• General guidelines for electrical
installation
• Mechanical installation of the model
THS/PH
• Electrical installation - General notes
• Non-integrated THS system supplied
without conveyor belt: detailed
construction notes and selection of
operating parameters
• Electrical installation: detailed notes
Switching on and checking the
safety devices
OPERATING INSTRUCTIONS SECTION
• Controls and indicators
• Switching on the metal detector
OPERATING INSTRUCTIONS SECTION
• Controls and indicators
• Switching on the metal detector
Preliminary operating checks:
Setting the applicable installation
parameters
OPERATING INSTRUCTIONS SECTION
• Automatic operation using a bar-code
reader
PROGRAMMING SECTION
• Programming instructions
Menus - Ejection
- THS Configuration
- ALM Configuration
- I/O status
INSTALLATION SECTION
• Non-integrated THS system supplied
without conveyor belt: detailed
construction notes and selection of
operating parameters
PROGRAMMING SECTION
• Programming instructions
Menus - Ejection
- THS Configuration
- ALM Configuration
- I/O status
Preliminary operating checks:
Functional check of the slave
devices: motor, ejector, signalling
devices etc.
OPERATING INSTRUCTIONS SECTION
• Signals given during use
• Use of the conveyor belt
• Alarm reset
PROGRAMMING SECTION
• Programming instructions
Menus - Ejection
- THS Configuration
- ALM Configuration
- I/O status
The availability of the various parameters on various models is indicated. If a parameter is
specific to the current product it is identified.
.
Preliminary operating checks:
Checking environmental
interference
OPERATING INSTRUCTIONS SECTION
• Checking for environmental electromagnetic interference
Preliminary operating checks:
Checking the sensitivity using a
sample supplied
OPERATING INSTRUCTIONS SECTION
• Analysis mode selection criteria
• Sensitivity check with reference sample
Memorisation of the products
being used with possible use of
an autolearn process
OPERATING INSTRUCTIONS SECTION
• Analysis mode selection criteria
• Programming the metal detector according to the kind of product
PROGRAMMING SECTION
• Programming instructions (Prod. command).
• Automatic operation using a bar-code reader
General guidelines for mechanical installation