THS – FI022GB2K8v3 --- V - MAINTENANCE
48
Operating instructions
List of preliminary checks
If the equipment is being switched on for the first time, some checks must be carried out and the value of some
operating parameters must be set. These operations, which are listed on the first page of the INSTALLATION
section, are described in the subsequent paragraphs in this section.
Operations during use and areas of competence
The system is designed to be managed by 6 different operators with different areas of competence:
• operator
• supervisor
• engineer
• quality-control operator
• head of quality control
• remote programmer
Access to programming differs between the various types of user (operator, supervisor, etc.) according to the following
table (see Programming section).
Operation to be carried out Programming access
level
Parameters or menus used
• Adjustment of sensitivity
Operator (if enabled)
Sensitivity Parameter
Supervisor
Engineer
Product Menu
• Choice of product
Operator
Product Parameter
Supervisor
Engineer
Product Menu
• Memorisation of new products
• Autolearn
• Counter management
Supervisor
Engineer
Product Menu
Autolearn Menu
Counter Menu
• Setting up periodic tests and test
reports
Head of quality control
MD Test Menu
QA Configuration Menu
• Carrying out periodic tests
Quality-control operator
Head of quality control
Test MD Menu
• Printing test reports
Head of quality control
Print Menu
• Setting detection and ejection
parameters
Supervisor
Engineer
Rec. parameters Menu (receiver)
Ejec. parameters Menu (ejector)
• Setting of installation parameters
Engineer
Barcode reader Menu
THS Configuration Menu
ALM Configuration Menu
• Checking of status of sensors and
actuators
Engineer
I/O Status Menu
* menu available only when a barcode reader is fitted.
N.B.: all the parameters shown in the table are accessible in remote mode
To Next Page
