Ceia THS - Connecting to a Metal Detector in a Network; 3.13.3 - Displaying a Parameter Setting; 3.13.4 - Changing a Parameter Setting; 3.13.5 - Executing a Function

THS – FI022GB2K8v3 --- V - MAINTENANCE
83
Connecting to a metal detector in a network
- Run the communications program
- Execute the PE command
- On the same line, enter the ID code and password (Head of
Quality Control) and key
ENTER
. The command prompt
will appear
#PE <ENTER>*
(LineID)(password)<ENTER>
#
* ENTER = ASCII code 013 Note: LineID always > 1000
3.13.3 - Displaying a parameter setting
Type the code of the parameter and press ENTER: the parameter
setting will appear next to it.
#SE<ENTER>
#SE 30
3.13.4 - Changing a parameter setting
#SE=35<ENTER>
#
Type the code of the parameter followed by the “=” character or a
space, the new value and ENTER.
#SE 35<ENTER>
#
3.13.5 - Executing a function
Key in the parameter code and press ENTER.
#PR<ENTER>
#