THS – FI022GB2K8v3 --- I -DESCRIPTION
3
Power-supply and control unit
The power-supply and control unit is housed in a watertight box in stainless steel which is designed to be attached by
means of four screws and through which pass the connecting cables. The power supply unit is available in two versions:
Control Power Box , containing the metal detector power supply section and designed to allow
connection of external sensors and slave devices
Conveyor Control System, with the same functions as the Control Power Box, but with the addition
of a conveyor belt motor driver/control section
Control Power Box
Fig. I-3a - Control Power Box in
stainless steel casing
Fig. I-3b – Internal view of the ALM
card
Fig. I-3c - Control Power Box with
RCU remote control panel (model
THS/G or other models on request)
The module contains only the electronics needed for supplying power to the probe and the connection terminals for
external sensors and slave devices. The card inside (card ALM), allows connections to be made to the following:
• metal detector probe
• mains power supply
• product transit photocell
• external activators and sensors
• personal computer
Fig. I-4 Control Power Box: rear and side views
To Next Page
Loading...
