M-Series Operator’s Manual 4/9/15
10-71
N0060 Circular pocket
Center: X :
4.0000
Y :
0.0000
Surface Height
:
0.0000
Diameter :
0.7500
Cleanout :
Yes
Depth: Total
:
0.5100
INC
Per Pass
:
0.2500
Plunge Rate
:
2.0000
Plunge Type
:
Ramped
Plunge Angle
:
0.00
°
Rough Cuts :
Conventional
Stepover
:
0.2000
Feedrate
:
2.0000
Finish Pass :
Climb
Amount
:
0.1000
Feedrate
:
2.0000
F10 - Accept Keep selected values.
F5 - Cycles Access the list of available Canned Cycles.
F5 - Rect. Pocket Cut the first rectangular pocket.
N0070 Rectangular pocket
Center: X :
2.0000
Y :
0.0000
Surface Height
:
0.0000
Length (X) :
0.7500
INC
Width (Y) :
0.4250
INC
Corner Radius :
0.1875
Depth: Total :
0.2500
INC
Per Pass
:
0.2500
Plunge Rate
:
2.0000
Plunge Type
:
Ramped
Plunge Angle
:
0.00
°
Rough Cuts :
Conventional
Stepover
:
0.1000
Feedrate
:
2.0000
Finish Pass :
None
Amount
:
0.0000
Feedrate
:
2.0000
F10 - Accept Keep selected values.
F5 - Cycles Access the list of available Canned Cycles.
F5 - Rect. Pocket Repeat above Pocket cycle. The center X value lies at 3.0000.
To Next Page
Loading...
