M-Series Operator’s Manual 4/9/15
10-79
Arc type :
EP&R
Mid X
:
Y
:
Z
:
End: X
:
0.7496
Y
:
-1.0003
Z
:
-0.0500
Center: X
:
Y
:
Z
:
Angle :
Radius :
3.1500
Plane :
XY
Direction :
CCW
Feedrate :
10.0000
Angle <= 180°
:
Yes
F10 - Accept Keep selected values.
F3 - Arc The third arc to be cut is labeled as ARC 3 in Figure 3. The start
point is labeled P2, the end point of the previous arc. The end
point of the arc will be generated with Math Help.
N0015 Arc
↑
↑↑
↑↓
↓↓
↓(UP/DOWN) Move down to the End X field. This selects End X as the
destination of the Math Help solution.
F6 - Math Help Redisplay the Math Help values calculated for the last arcs.
F9 - Graphic on/off Redisplays the diagram of the scenario selected to calculate arcs 1
and 2 on Figure 3.
F1 - Prev Soln Continue pressing F1 until you arrive at the scenario showing arcs
3 and 4 in Figure 3 (in this case, solution #1 is the appropriate
one)
To Next Page
Loading...
