M-Series Operator’s Manual 4/9/15
Parameter Definition Default setting
179 Lube Pump Operation 0
186 Probe Stuck retry disable 0
187 Hard Stop Homing Power Limit 0
188-199 Aux key functions 0
200-207 OPTIC4 Tach Volts Per RPM 0
208-215 MPU Lash/Screw Comp Acceleration Coefficient 0.125
216 PC Based Lash Compensation on/off 0
217 PC Based Screw Compensation on/off 0
220-231 Smoothing Parameters Refer to text
236-239 Motor Cooling Coefficients for axes 5,6,7,8 0
252-255 Autotune Ka Performance parameters for axes 5,6,7,8 0
256 Drive Mode 0
257 TT1 connection detection PLC input 0
258 Velocity/Torque Mode override in Precision mode 0
259 Manual Axis Designation 0
260 Accelerated Graphics Backplot on/off 1
270 Skew Correction: X Skew offset from Trusted/Intended X 0
271 Skew Correction: Trusted/Intended Y 0
278 Spindle Speed Display Precision 0
284-291 Brake Resistor Wattage for ACDC Drives 1-8 50
300-307 Drive assignment to Axes 1-8 Refer to text
308-315 Encoder assignment to Axes 1-8 Refer to text
323 MPU11 Encoder Speed Filter 0
324-331 Axis Boxcar size 0
332-335 Encoder error suppression 0
336-339 Motor torque estimation for velocity mode drives Refer to text
340-347 Precision Mode delay (in milliseconds) for axes 1-8 0
348,351,354
MPG 1,2,3 Encoder Input 15, 0, 0
349,352,355
MPG 1,2,3 Detents per Revolution 100
350,353,356
MPG 1,2,3 Encoder Counts per Revolution 400
357-364 Axis Drive Max RPM 0
365 Drive power-on delay 0.0
366 Probe deceleration multiplier 2.0
367 TT1 deceleration multiplier 2.0
374 ACDC Drive Debug Log Axis Inclusion 0
375 ACDC Drive Debug Log Size 0
376 ACDC Drive Debug Log Collection Type 0
377 ACDC Drive Debug Log Trigger Type 0
378 ACDC Drive Debug Log Trigger Level 0
379 ACDC Drive Debug Log Option 0
392-394 DP-7 parameters Refer to text
395 Probing setup traverse speed 30 ipm or 762 mm/min
396 Probing setup plunge speed 30 ipm or 762 mm/min
398 Port/block mode 0
399 AD1 arc chord tolerance adjustment .5
900-999 PLC program parameters --
To Next Page
Loading...
