Cisco ESW 500 - Defining SNTP Settings

Configuring System Time
Defining SNTP Settings
ESW 500 Series Switches Administration Guide 92
4
Defining SNTP Settings
The SNTP Settings Page contains information for enabling SNTP servers, as well
as adding new SNTP servers. In addition, the
SNTP Settings Page enables the
device to request and accept SNTP traffic from a server. To define SNTP global
settings:
STEP 1 Click Monitor & Device Properties > System Management > Time > SNTP
Settings. The
SNTP Settings Page opens:
SNTP Settings Page
The
SNTP Settings Page contains the following fields:
• Enable SNTP Broadcast Reception — Enables polling the selected SNTP
Server for system time information.
• SNTP Server — Indicates the SNTP server IP address. Up to eight SNTP
servers can be defined.
• Poll Interval — Defines the interval (in seconds) at which the SNTP server is
polled for system time information. By default, the poll interval is 1024 seconds.