Cisco ESW 500 - Modifying Interface Settings

Configuring Spanning Tree
Defining Spanning Tree Interface Settings
ESW 500 Series Switches Administration Guide 271
11
Modifying Interface Settings
STEP 1 Click VLAN & Port Settings > Spanning Tree (STP) > Interface Settings. The
Interface Settings Page opens:
STEP 2 Click the Edit button. The Edit Interface Settings Page opens:
Edit Interface Settings Page
The
Edit Interface Settings Page contains the following fields:
• Interface — Selects the port number on which Spanning Tree is configured.
• STP — Enables or disables STP on the port. The possible field values are:
- Enable — Enables STP on the port.
- Disable — Disables STP on the port.
• Port Fast — Indicates if Fast Link is enabled on the port. If Fast Link mode is
enabled for a port, the Port State is automatically placed in the Forwarding
state when the port link is up. Fast Link optimizes the STP protocol
convergence. STP convergence can take 30-60 seconds in large networks.
The possible values are: