Cisco ESW 500 - Modifying Multicast Forwarding

Configuring Multicast Forwarding
Defining Multicast Forwarding
ESW 500 Series Switches Administration Guide 260
10
- Dynamic — Attaches the port to the Multicast group as dynamic
member.
Modifying Multicast Forwarding
STEP 2 Click VLAN & Port Settings > Multicast > Forward. The Multicast Forward Page
opens:
STEP 3 Click the Edit button. The Edit Multicast Forward All Page opens:
Edit Multicast Forward All Page
The
Edit Multicast Forward All Page contains the following fields:
• VLAN ID — Displays the VLAN ID.
• Interface — Displays the port or EtherChannel attached to the Multicast Group.
• Interface Status — Displays the interface status of the port or EtherChannel.
The options are as follows:
- Static — Attaches the interface to the Multicast group as a static
member.
- Forbidden — Forbidden interfaces are not included the Multicast group,
even if IGMP snooping designated the interface to join a Multicast group.
- Excluded — The interface is not part of a Multicast group.
- Dynamic — Attaches the interface or EtherChannel dynamically to the
Multicast group.
STEP 4 Define the relevant fields.