Cisco ESW 500 - ARP Table

Configuring IP Information
Managing ARP
ESW 500 Series Switches Administration Guide 238
8
ARP Table
•
Interface — Indicates the interface for which the ARP parameters are defined.
• IP Address — Indicates the station IP address, which is associated with the
MAC address.
• MAC Address — Indicates the station MAC address, which is associated in the
ARP table with the IP address.
• Status — Indicates the ARP Table entry status. Possible field values are:
- Dynamic — Indicates the ARP entry was learned dynamically.
- Static — Indicates the ARP entry is a static entry.
STEP 2 Click Add. The Add ARP Page opens:
Add ARP Page
The
Add ARP Page contains the following fields:
• VLAN — Indicates the ARP-enabled interface.
• IP Address — Indicates the station IP address, which is associated with the
MAC address filled in below.
• MAC Address — Indicates the station MAC address, which is associated in the
ARP table with the IP address.
STEP 3 Define the relevant fields.
STEP 4 Click Apply. The ARP Settings are defined, and the device is updated.