Cisco ESW 500 - Modifying Protocol Groups

Configuring VLANs
Defining Protocol Groups
ESW 500 Series Switches Administration Guide 226
7
Add Protocol Group Page
The
Add Protocol Group Page provides information for configuring new VLAN
protocol groups. The
Add Protocol Group Page contains the following fields.
• Frame Type — Displays the packet type.
• Protocol Value — Defines the User-defined protocol value. The options are as
follows:
- Protocol Value — The possible values are IP, IPX, or ARP.
- Ethernet-Based Protocol Value — Specify the value in hexadecimal
format.
• Group ID — Defines the Protocol group ID to which the interface is added. The
possible value range is 1-2147483647 in hexadecimal format.
STEP 3 Define the relevant fields.
STEP 4 Click Apply. The Protocol Group is added, and the device is updated.
Modifying Protocol Groups
The Edit Protocol Group Page provides information for configuring existing VLAN
protocol groups
STEP 1 Click VLAN & Port Settings > VLAN Management > Protocol Group. The Protocol
Group Page
opens:
STEP 2 Click the Edit Button. The Edit Protocol Group Page opens: