Cisco ESW 500 - Modifying SNMP Notifications

To Next Page

To Previous Page

Configuring SNMP

Defining Trap Management

ESW 500 Series Switches Administration Guide 354

• Filter Name — Defines if the SNMP filter for which the SNMP Notification filter

is defined.

• Timeout — Indicates the amount of time (seconds) the device waits before re-

sending informs. The default is 15 seconds.

• Retries — Indicates the amount of times the device re-sends an inform request.

The default is 3 attempts.

STEP 3 Define the relevant fields.

STEP 4 Click Apply. The SNMP Notification Recipient settings are defined, and the device

is updated.

Modifying SNMP Notifications

The

Edit SNMP Notification Recipient Page

allows system administrators to define

notification settings. The

Edit SNMP Notification Recipient Page

is divided into four

areas, Notification Recipient, SNMPv1,2 Notification Recipient, SNMPv3

Notification Recipient and UDP Port Notification Recipient.

STEP 1 Click Monitor & Device Properties > SNMP > Trap Management > Station

Management.

STEP 2 Click the Edit button. The

Edit SNMP Notification Recipient Page

opens:

Related product manuals