Configuring SNMP
Defining Trap Management
ESW 500 Series Switches Administration Guide 350
13
Configuring Station Management
The
Station Management Page
contains information for defining filters that
determine whether traps are sent to specific users, and the trap type sent. SNMP
notification filters provide the following services:
• Identifying Management Trap Targets
• Trap Fi ltering
• Selecting Trap Generation Parameters
• Providing Access Control Checks
Traps indicating status changes are issued by the switch to specified trap
managers. Specify the trap managers so that key events are reported by this
switch to the management station. Specify up to eight management stations that
receive authentication failure messages and other trap messages from the switch.
STEP 1 Click Monitor & Device Properties > SNMP > Trap Management > Station
Management. The
Station Management Page
opens:
Station Management Page
The
Station Management Page
contains two areas, the
SNMPv1,2 Notification
Recipient
and the
SNMPv3 Notification Recipient
table.
To Next Page
Loading...
