Cisco ESW 500 - Page 360

Configuring SNMP
Defining Trap Management
ESW 500 Series Switches Administration Guide 349
13
STEP 1 Click Monitor & Device Properties > SNMP > Trap Management > Trap Settings.
The
Trap Settings Page opens:
Trap Settings Page
The
Trap Settings Page contains the following fields:
• Enable SNMP Notification — Specifies whether the device can send SNMP
notifications. The possible field values are:
- Checked — Enables SNMP notifications.
- Unchecked — Disables SNMP notifications.
• Enable Authentication Notification — Specifies whether SNMP authentication
failure notification is enabled on the device. The possible field values are:
- Checked — Enables the device to send authentication failure
notifications.
- Unchecked — Disables the device from sending authentication failure
notifications.
STEP 2 Define the relevant fields.
STEP 3 Click Apply. The SNMP Trap settings are defined, and the device is updated.