Cisco ESW 500 - Modifying ARP Settings

Configuring IP Information
Managing ARP
ESW 500 Series Switches Administration Guide 239
8
Modifying ARP Settings
STEP 1 Click Monitor & Device Properties > System Management > IP Addressing > ARP.
The
ARP Page opens:
STEP 2 Click the Edit button. The Edit ARP Page opens:
Edit ARP Page
The
Edit ARP Page contains the following fields:
• VLAN — Indicates the ARP-enabled interface.
• IP Address — Indicates the station IP address, which is associated with the
MAC address filled in below.
• MAC Address — Indicates the station MAC address, which is associated in the
ARP table with the IP address.
• Status — Defines the ARP Table entry status. Possible field values are:
- Dynamic — Indicates the ARP entry is learned dynamically.
- Static — Indicates the ARP entry is a static entry.
STEP 3 Define the relevant fields.
STEP 4 Click Apply. The ARP Settings are modified, and the device is updated.