Managing System Files
Save Configuration
ESW 500 Series Switches Administration Guide 364
14
• BACKUP — Specifies that firmware is uploaded for a firmware backup.
• via TFTP — Indicates that the upgrade file is found on a TFTP server.
• via HTTP — Indicates that the upgrade file is found on a HTTP server.
• File Type — Specifies the file type of the downloaded file (for TFTP download
only). The possible field values are:
-
Software Image
— Downloads the Image file.
-
Boot Code
— Downloads the Boot file.
NOTE Boot image upgrade is supported by TFTP protocol, but not
supported by HTTP protocol.
• TFTP Server — Specifies the TFTP Server IP Address from which files are
downloaded.
• Source File — Specifies the file to be downloaded. This field is applicable for
UPGRADE only.
• Destination File — Specifies the file name on the TFTP server where the
uploaded file is saved. This field is applicable for BACKUP only.
STEP 2 Define the relevant fields.
STEP 3 Click Apply. Firmware upgrade is defined, and the device is updated.
Save Configuration
In the
Save Configuration
Page, network administrators can save configuration
files on the device.
In the
Save Configuration Page
, network administrators can copy configuration
files from one device to another.
These steps can be done from the Menu-Based CLI or from the web interface.
• Copy image from TFTP to device
• Change active image on device
• Reboot device
To Next Page
Loading...
