Cisco ESW 500 - Defining STP Properties

Configuring Spanning Tree
Defining STP Properties
ESW 500 Series Switches Administration Guide 265
11
STEP 1 Click VLAN & Port Settings > Spanning Tree (STP) > Properties. The STP
Properties Page
opens:
STP Properties Page
The
STP Properties Page contains the following fields:
Global Settings
The Global Settings area contains device-level parameters.
• Spanning Tree State — Indicates if STP is enabled on the device. The possible
field values are:
- Enable — Enables STP on the device. This is the default value.
- Disable — Disables STP on the device.
• STP Operation Mode — Indicates the STP mode that is enabled on the device.
The possible field values are:
- Classic STP — Enables Classic STP on the device. This is the default
value.