Getting Started
Connecting to the Switch
ESW 500 Series Switches Administration Guide 10
1
IPv4 Interface Page
NOTE It is expected that the IP address to be assigned to the switch is known prior
to installation, based on the network topology.
STEP 10 Select the Static IP address radio button and enter the IP Address, Network Mask
and User Defined Default Gateway. These must match the IP addressing subnet in
the network in which the ESW 500 switch will be deployed. Click Apply.
NOTE The PC loses the connection to the switch at this point.
STEP 11 Now that you have finished using the PC to connect to the switch and made the
switch part of your network, you can reconfigure the PC to its original IP address
configuration and physical configuration as part of your network.
STEP 12 You are now ready to proceed with additional switch configuration.
To Next Page
Loading...
