Cisco ESW 500 - Page 267

Configuring Multicast Forwarding
Defining Multicast Group
ESW 500 Series Switches Administration Guide 256
10
• Enable Bridge Multicast Filtering — Indicates if Bridge Multicast Filtering is
enabled on the device. Bridge Multicast Filtering can be enabled only if IGMP
Snooping is enabled. The possible field values are:
- Checked — Enables Multicast Filtering on the device.
- Unchecked — Disables Multicast Filtering on the device.
• VLAN ID — Specifies the VLAN ID.
• Bridge Multicast Address — Identifies the Multicast group MAC address.
• Ports — Displays the Multicast Group ports’ status.
• EtherChannels — Displays the Multicast Group status of all of the device’s
EtherChannels.
• Interface — Displays the interface on which the Multicast service is configured.
• Interface Status — Displays the interface status. The options are as follows:
- Static — Attaches the interface to the Multicast group as static member
in the Static Row. The interface has joined the Multicast group statically
in the Current Row.
- Forbidden — Forbidden interfaces are not included the Multicast group,
even if IGMP Snooping designated the interface to join a Multicast
group.
- None — The interface is not part of a Multicast group.
STEP 2 Click the Add button. The Add Multicast Group Page opens:
Add Multicast Group Page
The
Add Multicast Group Page contains the following fields:
• VLAN ID — Displays the VLAN ID.