Cloos QINEO - User Log On;Off; MAIN (2) - Log on; MAIN (2) - Log off

105
14. User log on/off
14.1 MAIN (2) - Log on
As described in paragraph "10.6.1 Config - Access management", the weld-
ing power source is provided with different operating levels as a protection
against unauthorised use. To enter your access code, press the "Log-on"
function. The current operating level is shown in the upper part of the
display.
You can now enter your personal access code in the lower part of the dis-
play. The access code is activated by pressing rotary knob 3!
After 5 unsuccessful attempts to enter the password, an 8-digit code num-
ber appears below the "Access code" line. With the aid of the code number
it is possible to decode the password by calling the CLOOS Service Hotline.
You can now enter the code number again.
14.2 MAIN (2) - Log off
If the "Log-off" function is activated, the control immediately returns to the
adjusted operating level "Operating level after switching on", see section
"10.6.1 Config - Access management".
INFO!