CHAMP Pro
36
As a standard feature, a CLOOS SZ connection is provided as
torch connection.
Optionally, an Euro connection or a Dinse connection can be
supplied.
The machine has an optional CAN interface to operate/
interrogate various functions in the automation technology.
The QINEO CHAMP Pro can be equipped with a weld data
monitoring module.
Assembly
A complete machine includes:
1. QINEO CHAMP Pro pulsed arc welding machine
2. QINEO Wire Drive unit
3. Connection cable assembly
4. MIG/MAG welding torch
5. Standard equipment
6. If required, mains voltage cable with CEE plug
The individual components such as MIG/MAG welding
machine, possibly cable assembly with wire drive unit, MIG/
MAG welding torch, shielding gas cylinder and reducing
valve have to be assembled.
In the case of welding machines with liquid cooling: Insert
the plug nipples of the cable assembly into the connection
nipples of the power source. The water hoses must not be
exchanged. Otherwise this would result in an insufficient
cooling of the welding torch. The flow is marked blue!
Fill in the coolant. All water-cooled machines are supplied
with a 5 litre container of ready-to-use mixture.
The ground cable is connected to the current connector and
locked by turning to the right.
The gas cylinder is placed on the base plate at the rear of the
machine and is secured by a chain, which is connected to the
holder.
6. Commissioning
To Next Page
Loading...
