Cloos QINEO - MHW 405 TQ (2-Button Torch)

111
Qineo welding power sources can be provided with a remote control on the
welding torch. The connection is made via the remote controller socket at
the QWD.
Use the configuration menu of the welding power source to determine
which of the following parameters shall be changed in which step width
and speed by means of the remote control:
• Power
• Fine adjustment ( ArcLength)
• Dynamics (ArcDynamic)
• Job
Depending on the operating module, please read the corresponding sec-
tion of block 3 of this operating manual.
2. MHW 405 TQ
(2-button torch)
Figure 69. MHW 405 TQ