Cloos QINEO - Error List

147
1.1 Error list
No.
Error message on the
display
Possible cause Remedy
1 CAN connection faulty
Interruption of CAN bus between
control and operating module
Check plug and connections to the
operating module
Service
2
Error when loading
the job data of the
operating module
Operating module cannot call up
the information of the control.
Switch machine Off and On
Check cable connections
Service
3
Error when loading the
minimum values of the
operating module
Operating module cannot call up
the information of the control.
Switch machine Off and On
Check cable connections
Service
4
Error when loading the
maximum values of the
operating module
Operating module cannot call up
the information of the control.
Switch machine Off and On
Check cable connections
Service
5
Error when loading the
configuration of the
operating module
Operating module cannot call up
the information of the control.
Switch machine Off and On
Check cable connections
Service
6
Error when loading the
job list
Operating module cannot call up
the information of the control.
Switch machine Off and On
Check cable connections
Service
7
Error when loading the
version data
Operating module cannot call up
the information of the control.
Switch machine Off and On
Check cable connections
Service
8
Error during
transmission of the
option code
Operating module cannot call up
the information of the control.
Switch machine Off and On
Check cable connections
Service
9
Characteristic curve
allocation error (only
Eco-Master operating
modules)
May appear after loading new
characteristic curves if material/gas
combinations in the config are set
incorrectly.
Call up characteristic curves again
Check characteristic curve allocation
Service
10
Job does not contain any
data
Job does not exist in the controller.
May appear in case of external job
selection
Check job selection
Create new job
Service
11
Job has wrong check
sum
Error in job file.
Check job selection
Create new job
Service
14
No valid characteristic
curve on weld start
Invalid material/gas combination
and/or process selection.
• ECO/Master: Material/gas LEDs
are blinking.
• Premium: Parameters in the
main menu are shown in red.
Select valid characteristic curve
Service
15
Error in the offsets of
current and voltage
measurement
Error in the digital signal processor
(DSP).
Switch machine Off and On
Service