137
6.3 Installation/change of the wire drive rollers
Stab injury!
In the case of an incorrect handling of the welding torch during the wire
feeding process, the wire transport may cause stab injuries on hand, eyes
or the face. During the wire feeding, you should always keep the welding
torch in a position turned away from the body!
• Please take care that the current tip is removed from the torch.
Isolate the welding power source from the power supply before you start
the change.
6.3.1 QWD-M
The illustrations may differ from the original.
WARNING!
CAUTION!
INFO!
2
1
43
To Next Page
Loading...
