Cloos QINEO - Normal CW; Rapid Weld

52
MAIN process
5.7.2 Normal CW
This is a MIG/MAG welding process without pulse but with synergy func-
tion. The welding current depends on the distance between torch and
workpiece. In connection with the QIROX robot application, arc seam track-
ing is possible to a limited extent. This welding process is suitable for sheet
thicknesses from 0.5 mm - 3.0 mm.
5.8 Rapid Weld
The Rapid Weld process generates a very concentrated arc during the weld-
ing process, which guarantees a very deep penetration.
The following characteristic curves are available as Rapid Weld variant:
• Normal, Fe, 92 % Ar, 8 % CO
2
, wire 1.0 mm
• Normal, Fe, 92 % Ar, 8 % CO
2
, wire 1.4 mm
• Normal, Fe, 82 % Ar, 18 % CO
2
, wire 0.8 mm
• Normal, Fe, 82 % Ar, 18 % CO
2
, wire 1.0 mm
• Normal, Fe, 82 % Ar, 18 % CO
2
, wire 1.2 mm
• Normal, Fe, 82 % Ar, 18 % CO
2
, wire 1.4 mm
• Normal, Fe, 82 % Ar, 18 % CO
2
, wire 1.6 mm
• Normal, Fe, 91 % Ar, 4 % O
2
, 5% CO
2
, wire 1.2 mm
• Normal, Fe, 91 % Ar, 4 % O
2
, 5% CO
2
, wire 1.4 mm
• Normal, Fe, 91 % Ar, 4 % O
2
, 5% CO
2
, wire 1.6 mm
To activate the Rapid Weld characteristic curve, you have to select one of
the above mentioned characteristic curves and the variant 1 M or Rapid
Weld at the PREMIUM operating module.
(Main/Synergy/Variant --> variant 1 M).
INFO!