Cloos QINEO - Commissioning; Safety Instructions for Commissioning; Risks Due to Mechanical Hazards; Risks Due to Electrical Hazards

135
6. Commissioning
6.1 Safety instructions for commissioning
The QINEO Wire Drive must not be operated if it has visible damage or
defects, which may lead to a hazard:
• Prior to commissioning the wire drive unit, check to see if the wire
guide, the connection line and the casing are damaged.
6.1.1 Risks due to mechanical hazards
Risk of being pulled in by the drive rollers
Loose clothing, jewellery or long, loose hair can be caught by the drive
rollers and cause severe injuries.
• Wear fitted work clothing.
• Do not wear jewellery.
• Pull your hair back when working.
6.1.2 Risks due to electrical hazards
Risk of electric shock
If unrestricted access to the back side of the QINEO Wire Drive is possible,
all persons must exercise caution to prevent electric shock or risks from
electrical energy.
• Always disconnect the device when working at the back side of the
QINEO Wire Drive.
• Even if the QINEO Wire Drive is switched off, it may be under voltage!
• Only trained specialists may work on the device.
ATTENTION!
WARNING!
WARNING!