Cloos QINEO - Wire Forward; Wire Backward; Gas Manually; Start Manually

54
MAIN - Function
6.4 Wire forward
With this function the wire feed is switched on manually.
This function is only active as long as the button is pressed.
6.5 Wire backward
This function is used to manually retract the wire electrode.
This function is only active as long as the button is pressed.
6.6 Gas manually
The function is used for an exact setting of the gas flow (gas control cone,
pressure reducer).
With this function the gas valve is switched on manually.
The function is activated/deactivated by a short key press. If the button is
pressed for more than 0.5 s, the function is only active as long as the but-
ton is pressed.
6.7 Start manually
This function triggers a manual start command.
In the lower part of the display, the Hold value is shown for approx. 10 s
(yellow points).
This function is only active as long as the button is pressed.
F U N K T I O N E N
Puls 4 -Takt
V
0
A
1.2 mm Fe
82% Argon 18% Co
2
0.0
Clean
Start
Air
Funktionen
F U N K T I O N E N
Puls 4 -Takt
V
0
A
1.2 mm Fe
82% Argon 18% Co
2
0.0
Clean
Start
Air
Funktionen
F U N K T I O N E N
Puls 4 -Takt
V
0
A
1.2 mm Fe
82% Argon 18% Co
2
0.0
Clean
Start
Air
Funktionen
F U N K T I O N E N
Puls 4 -Takt
V
0
A
1.2 mm Fe
82% Argon 18% Co
2
0.0
Clean
Start
Air
Funktionen