Cloos QINEO - Config - User Management - User Overview

88
MAIN (2) - Config (Configuration)
Call up a Job
Name Function
Enable You can call jobs without login.
Lock
You can only call jobs after login with your password
or PAK.
Rotary knob
In this menu item you can select the following functions:
Name Function
Enable Power /
Fine
You can change both parameters.
Enable Fine You can change the parameter "Fine adjustment"
Lock Power/Fine You cannot change both parameters.
10.6.2.2 Config - User management - User overview
You can only do changes in the "Config" - "User management - User
overview" menu if you are logged in at the welding power source with the
"Configurator" operating level.
This menu lists all allowed user names (maximum 30 characters). The
number of the user names is restricted to 20. Every user name is listed with
the corresponding operating level.
INFO!
Puls 4 -Takt
V
0
A
1.2 mm Fe
82% Argon 18% Co
2
0.0
Konfig – Benutzerübersicht
Level
PAK
Program-
mieren
Benutzer
Konfigurator
K Mustermann
P J.Mustermann
- ………………………………………………
- ………………………………………………
- ………………………………………………
- ………………………………………………
- ………………………………………………
- ………………………………………………
- ………………………………………………
- ………………………………………………
- ………………………………………………
- ………………………………………………
- ………………………………………………
- ………………………………………………
- ………………………………………………
- ………………………………………………
- ………………………………………………
Benutzer
Löschen
A K.Mustermann
Figure 45. Config - User overview