86
MAIN (2) - Config (Configuration)
information saved in the welding power source. The respective user profile
is then activated in the welding power source.
If a user logs in who is new for the welding power source, the access is
either denied or his user profile is transferred into the user management
and stored, depending on the setting. The respective user profile is then
activated in the welding power source.
Operating level after switching on
This menu item enables you to determine the preset operating level
after switching on the welding power source. You can select between
"Automatic", "Programmer" and "Configurator".
Transfer of PAK files
In this menu item you can select the following functions:
Name Function
Allowed (default)
Unknown users are allowed to log in at the weld-
ing power source.
Information of unknown users are saved at the
welding power source.
Not allowed
Only users who are listed in the configuration of
the welding power source are allowed to log in.
Welding process enable
In this menu item you can select the following functions:
Name Function
Always
The welding power source always activates the
welding process, even if no user is logged in.
After login (default)
The welding power source only activates the
welding process after successful login.
Job range enable
In this menu item you can select the following functions:
Name Function
All
The user can call and use all jobs (1 … 999) which
are stored in the welding power source.
Allowed jobs
(default)
The user can only call and use the allowed jobs.
It is possible to specify defined parameter limits (setting ranges) within
a job for the "Automatic" and "Programmer" operating levels, see section
"7.4 Setting ranges" on page 60.
INFO!
To Next Page
Loading...
