Engineering Manual Engineer Menu 1-4
49
069 – Always Off
This output never activates.
070 – Auxiliary Fuse
Activates when the panel's auxiliary 12V fuse is blown.
If you want to use this event for a output that is powered by the panel, the output must
be configured so that its normal state is "on" to indicate the presence of power, and "off"
means power is off. If you are using a switched-negative digital communicator output,
this means that the sense of the output must be inverted. Note that the communicator
must be powered from a different source for the power failure to be communicated.
071 – Bell Fuse
Activates when the polyfuse protecting the bell output fuses.
072 – Network 1 Fuse
Activates when the polyfuse protecting the Network 1 output fuses. Do not use this event
for outputs connected to any device on network 1.
073 – Network 2 Fuse
Activates when the polyfuse protecting the Network 2 output fuses. Do not use this event
for outputs connected to any device on network 2.
074 to 079 – Always Off
This output never activates.
080 – Rem Batt Fault
This activates when there is battery fault at any MSPSU.
081 – Rem Mains Off
This activates when mains power switches off at any MSPSU.
082 – Rem Pwr Out Flt
This activates when the voltage from any MSPSU power supply is too high or too low. This
may indicate excessive loading (voltage too low).
083 – Sys Batt Fault
This activates when there is a fault with the battery in the control panel or any MSPSU.
084 – Sys Mains Fault
This activates when mains power switches off at the control panel or in any MSPSU.
085 to 099 – Always Off
This output never activates.
100 – Auto-Setting
Activates for 1 minute prior to any ward being set automatically by an auto-set timer
(page 63).
101 – Auto-Set Timer 1
Activates when Auto-set timer 1 (page 63) is on; deactivates when timer is off.
102 – Auto-Set Timer 2
Activates when Auto-set timer 2 is on; deactivates when timer is off.
To Next Page
Loading...
