Engineering Manual Engineer Menu 1-5
63
Option 1-5-4: Defining Auto-Set Timers
Timers 4
Auto-Sets
Auto-Set 1
e.g.
Auto-Set 2
Auto Set 2
On (1) 00:00
uto Set 2
On (2) >00:00
[
[
[
|
e.g.
X
To select the auto-set timer to set up:
Press or
"
"
|¬
to scroll, or
Press the hot key (1 to 3)
1. SELECT TIMER
Each auto-set timer has three pairs of switch on/off times. For
each of these, you will notice that there is an option to specify the
on (set) time, one to specify the off (unset) time and another to
specify the days of operation.
You can manually override an auto-set timer by pressing , then
pressing to toggle its current status.
0
r
You will see a screen similar to
the above if you have chosen
to edit an on/off time. The
number in brackets indicates
whether it is the first, second or
third pair of on/off times. Enter
the time in 24-hour format
(e.g. 2100 for 9pm), then press
.
Press again to set up other
parts of the timer, or press
to exit.
[
[
]
You will see a screen similar
to this if you have chosen to
edit days of operation. The
number in the top-left corner
indicates whether it is
associated with the first,
second or third pair of on/off
times. Press 1 to 7 to toggle
days on/off, then press .
Press again to set up
other parts of the timer, or
press to exit.
[
[
]
If you have pressed , you can
use the numeric keys to select
the wards to assign to the auto-
set time, then press . Any ward
numbers shown are assigned. (A
"." indicates that the ward will not
be assigned, and "." indicates
that you have no access to the
ward.
Press again to set up other
parts of the timer, or press to
exit.
r
[
[
]
2. SELECT ON/OFF TIME
OR DAYS TO EDIT
e.g. press 7 times
|
r
1 Operates On :-
> ..............
uto Set 2
Ward > **
This option enables you to define up to three auto-sets timers. Each is associated with one or
more wards, which automatically set and unset at the specified times.
You can define each auto-set timer to have up to three pairs of switch on (set) and off (unset)
times. You can also choose the days of the week that each of these operate.
The option is also available from User option 2-0-2.
The outputs controlled by the time switches (page 49 and 55) are specified in Engineer option
1-4. Refer also to the Defer Setting timer (page 60).
To Next Page
Loading...
