Cooper Security M750 - Option 1-8-3: Setting the Ward Group Timers

Engineering Manual Engineer Menu 1-8
71
 When setting ward 1, "Timed Exit" is used.
 When setting ward 2, "Instant Set" is used.
Option 1-8-3: Setting the Ward Group Timers
Group Options 3
Group Timers
Group Timers 1
Exit
e.g.
e.g.
[
Eng 1 Menu 8
Group Options
Group Timers 2
Entry
Entry Timer >1
015 Seconds
Entry Timer 2
> 015 Seconds
Entry Timer >2
015 Seconds
Entry Timer 2
> 016 Seconds
Group Options 1
Assign Groups
[
[
|
|
[
[
3
|
e.g.
X
To select the timer type:
Press or
"
"
|¬ to scroll, or
Press the hot key (1 to 4)
Press to save changes [
1. SELECT "GROUP
TIMERS" OPTION
2. SELECT TIMER
TYPE
To select group:
Press or
"
"
|¬ to scroll, or
Press the hot key (e.g. 2)
To select timer value:
Press or
"
"
|¬ to scroll, or
Enter the value (e.g. 010)
3. SELECT GROUP
4. EDIT TIMER VALUE
This option is relevant only when a user sets wards through a ward group. The option specifies
the timer values for the wards in the selected ward group. You can specify different timer
settings for each ward group.
When a ward group is set, the timer values you specify here are used instead of the values
specified in option 1-5-1 (page 57). Page 70 gives an example of how ward group setting
modes are used; ward group timers operate in a similar way.