Danfoss VACON 100 FLOW Series User Manual

•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
10 Monitoring Value Descriptions
10.1 Multimonitor
10.1.1 (ID 25) Frequency Reference
Location in the menu with default settings: V2.1.1 (In Multimonitor menu)
Location in the menu: V2.3.2 (In Basic menu)
This monitoring value shows the actual frequency reference to the motor control.
The value is updated at 10 ms interval.
10.1.2 (ID 1) Output Frequency
Location in the menu with default settings: V2.1.2 (In Multimonitor menu)
Location in the menu: V2.3.1 (In Basic menu)
This monitoring value shows the actual output frequency to the motor.
10.1.3 (ID 3) Motor Current
Location in the menu with default settings: V2.1.3 (In Multimonitor menu)
Location in the menu: V2.3.4 (In Basic menu)
This monitoring value shows the measured current of the motor.
The scaling of the value is different for different drive sizes.
10.1.4 (ID 2) Motor Speed
Location in the menu with default settings: V2.1.4 (In Multimonitor menu)
Location in the menu: V2.3.3 (In Basic menu)
This monitoring value shows the actual speed of the motor in RPM (calculated value).
10.1.5 (ID 5) Motor Shaft Power
Location in the menu with default settings: V2.1.5 (In Multimonitor menu)
Location in the menu: V2.3.7 (In Basic menu)
This monitoring value shows the actual shaft power of the motor (calculated value) as a percentage of the motor nominal power.
10.1.6 (ID 8) Unit Temperature
Location in the menu with default settings: V2.1.6 (In Multimonitor menu)
Location in the menu: V2.3.11 (In Basic menu)
This monitoring value shows the measured heat sink temperature of the drive.
The unit of measurement is degrees Celsius or Fahrenheit, depending on parameter C/F Selection (ID 1197) value.
10.1.7 (ID 7) DC Link Voltage
Location in the menu with default settings: V2.1.7 (In Multimonitor menu)
Location in the menu: V2.3.10 (In Basic menu)
This monitoring value shows the measured voltage in the DC link of the drive.
10.1.8 (ID 4) Motor Torque
Location in the menu with default settings: V2.1.8 (In Multimonitor menu)
Location in the menu: V2.3.5 (In Basic menu)
This monitoring value shows the actual torque of the motor (calculated value).
AB298035655957en-000201 / DPD01083 | 151Danfoss A/S © 2023.08
Monitoring Value Descriptions
VACON® 100 FLOW
Application Guide

Danfoss VACON 100 FLOW Series Specifications

General

Brand	Danfoss
Model	VACON 100 FLOW Series
Category	DC Drives
Language	English