Danfoss VACON 100 FLOW Series User Manual

10.3.5 (ID 60) Analog Input 2
Location in the menu: V2.4.5
This monitoring value shows the value of the analog input signal as a percentage of the used range.
10.3.6 (ID 61) Analog Input 3
Location in the menu: V2.4.6
This monitoring value shows the value of the analog input signal as a percentage of the used range.
10.3.7 (ID 62) Analog Input 4
Location in the menu: V2.4.7
This monitoring value shows the value of the analog input signal as a percentage of the used range.
10.3.8 (ID 75) Analog Input 5
Location in the menu: V2.4.8
This monitoring value shows the value of the analog input signal as a percentage of the used range.
10.3.9 (ID 76) Analog Input 6
Location in the menu: V2.4.9
This monitoring value shows the value of the analog input signal as a percentage of the used range.
10.3.10 (ID 81) SlotA AO 1
Location in the menu: V2.4.10
This monitoring value shows the value of the analog output as a percentage of the used range.
10.4 Temperature Inputs
The monitoring values related to temperature input settings are only available if a B8 or BH option board is installed.
10.4.1 (ID 50) Temperature Input 1
Location in the menu: V2.5.1i
This monitoring value shows the measured value of the temperature. The unit of the monitoring value is degrees Celsius or Fahren-
heit, depending on parameter C/F Selection (ID 1197) value.
The list of temperature inputs is made of the first 6 available temperature inputs. The list starts from slot A and ends in slot E. If an
input is available but no sensor is connected, the list shows the maximum value because the measured resistance is endless. To
make the value go to its minimum value, hardwire the input.
10.4.2 (ID 51) Temperature Input 2
Location in the menu: V2.5.2
This monitoring value shows the measured value of the temperature. The unit of the monitoring value is degrees Celsius or Fahren-
heit, depending on parameter C/F Selection (ID 1197) value.
10.4.3 (ID 52) Temperature Input 3
Location in the menu: V2.5.3
This monitoring value shows the measured value of the temperature. The unit of the monitoring value is degrees Celsius or Fahren-
heit, depending on parameter C/F Selection (ID 1197) value.
10.4.4 (ID 69) Temperature Input 4
Location in the menu: V2.5.4
This monitoring value shows the measured value of the temperature. The unit of the monitoring value is degrees Celsius or Fahren-
heit, depending on parameter C/F Selection (ID 1197) value.
10.4.5 (ID 70) Temperature Input 5
Location in the menu: V2.5.5
This monitoring value shows the measured value of the temperature. The unit of the monitoring value is degrees Celsius or Fahren-
heit, depending on parameter C/F Selection (ID 1197) value.
AB298035655957en-000201 / DPD01083154 | Danfoss A/S © 2023.08
Monitoring Value Descriptions
VACON® 100 FLOW
Application Guide

Danfoss VACON 100 FLOW Series Specifications

General

Brand	Danfoss
Model	VACON 100 FLOW Series
Category	DC Drives
Language	English