Danfoss VACON 100 FLOW Series - Going into the Control Page

3.

4.

1.
2.

3.

To select Local or Remote, use the arrow buttons Up and Down again. To accept the selection, push the [OK] button.
READY
FAULT
ALARM
STOP
RUN
KEYPAD
I/O
REV
FWD
BUS
e30bg682.10
If Remote control place is changed to Local, that is, the keypad, give a keypad reference.
After the selection, the display goes back into the same location where it was when the [FUNCT] button was push-
ed.
2.4.4.3 Going into the Control Page
It is easy to monitor the most important values in the Control page.
See more information about Keypad Reference in 6.3 Group 3.3: References. If other control places or reference values are used, the
display shows the frequency reference that cannot be edited. The other values on the page are Multimonitor values. These values
can be selected (see 5.2.1 Changing the Items to Monitor).
Procedure
Anywhere in the menu structure, push the [FUNCT] button.
To select the Control page, push the arrow buttons Up and Down. Go in with the [OK] button.
The Control page opens.
READY
FAULT
ALARM
STOP
RUN
KEYPAD
I/O
REV
FWD
BUS
e30bg683.10
If the Local control place and the keypad reference are used, P3.3.1.8 Keypad Reference can be set with the [OK] button.
READY
FAULT
ALARM
STOP
RUN
KEYPAD
I/O
REV
FWD
BUS
e30bg684.10
AB298035655957en-000201 / DPD0108326 | Danfoss A/S © 2023.08
User Interfaces
VACON® 100 FLOW
Application Guide