Danfoss VACON 100 FLOW Series User Manual

3 Applications
3.1 Using the Applications
Use the parameter P1.2 (Application) to select an application for the drive. Immediately when the parameter P1.2 changes, parame-
ter groups get their preset values.
3.2 Standard and HVAC Applications
Use the Standard and HVAC applications to control pumps or fans, for example.
It is possible to control the drive from the control panel (keypad), Fieldbus, or I/O terminal.
When the drive is controlled with the I/O terminal, the frequency reference signal is connected to AI1 (0…10 V) or AI2 (4…20 mA).
The connection depends the type of the signal. There are also 3 preset frequency references available. The preset frequency referen-
ces can be activated with DI4 and DI5. The start/stop signals of the drive are connected to DI1 (start forward) and DI2 (start reverse).
It is possible to configure all the drive outputs freely in all the applications. There is 1 analog output (Output Frequency) and 3 relay
outputs (Run, Fault, Ready) available on the basic I/O board.
AB298035655957en-000201 / DPD01083 | 29Danfoss A/S © 2023.08
Applications
VACON® 100 FLOW
Application Guide

Danfoss VACON 100 FLOW Series Specifications

General

Brand	Danfoss
Model	VACON 100 FLOW Series
Category	DC Drives
Language	English