Danfoss VACON 100 FLOW Series - 2.4 Text Display

1.
2.

3.
1.
2.
3.

4.
A
The current value
B
The value of the other set
C
The current value
D
The value of the other set
2.3.8 Reading Help Texts
The graphical display can show help texts on many topics. All the parameters have a help text. The help texts are also available for
the faults, alarms, and the start-up wizard.
N O T I C E
The help texts are always in English.
Procedure
Find the item to read.
Use the arrow buttons Up and Down to select Help.
STOP
READY I/O
ID:403 M3.5.1.1
Ctrl signal 1 A
Edit
Help
Add to favourites
e30bg679.10
To open the help text, push the [OK] button.
2.3.9 Using the Favourites Menu
If the same items are used frequently, add them into Favourites. Collect a set of parameters or monitoring signals from all the con-
trol panel menus. See
9.2.2 Adding an Item to the Favourites.
2.4 Text Display
2.4.1 Editing the Text Values
This topic gives instructions on how to edit text values on the text display.
Procedure
Find the parameter with the arrow buttons.
To go to the Edit mode, push the [OK] button.
To set a new value, push the arrow buttons Up and Down.
READY
FAULT
ALARM
STOP
RUN
KEYPAD
I/O
REV
FWD
BUS
e30bg680.10
Accept the change with the [OK] button. To ignore the change, use the [BACK/RESET] button.
AB298035655957en-000201 / DPD0108324 | Danfoss A/S © 2023.08
User Interfaces
VACON® 100 FLOW
Application Guide