Danfoss VACON 100 FLOW Series - Page 248

PT
A
B C
e30bg313.10
Illustration 85: The Location of the Pressure Sensor
A
Mains
B
Inlet
C
Outlet
e30bg314.10
Input Pressure
Supervision
Fault Level
Input Pressure Alarm
(Digital output signal)
Supervision
Alarm Level
Input Pressure Monitor
PID Setpoint
PID Setpoint
Supervision
Fault Delay
Supervision
Fault Delay
Motor Running
Yes
No
PID Setpoint
Reduction
Illustration 86: The Input Pressure Supervision Function
11.15.9.1 (ID 1685) Enable Supervision
Location in the menu: P3.13.9.1
Use this parameter to enable the Input Pressure Supervision function. Use this function to make sure that there is enough fluid in
the inlet of the pump.
11.15.9.2 (ID 1686) Supervision Signal
Location in the menu: P3.13.9.2
Use this parameter to select the source of the input pressure signal.
AB298035655957en-000201 / DPD01083248 | Danfoss A/S © 2023.08
Parameter Descriptions
VACON® 100 FLOW
Application Guide