Danfoss VACON 100 FLOW Series - Page 5

5.10
5.11
5.12
5.13
5.14
5.15
6
6.1
6.2
6.3
6.4
6.5
6.6
6.7
6.8
6.9
6.10
6.11
6.12
6.13
6.14
6.15
6.16
6.17
6.18
6.19
6.20
6.21
6.22
7
7.1
7.1.1
7.1.2
7.1.2.1
7.1.2.2
7.1.2.3
7.1.3
External PID Controller Monitoring 82
Multi-pump Monitoring 82
Monitoring of Maintenance Counters 83
Fieldbus Process Data Monitoring 83
Drive Customizer Monitoring 85
Condition-based Monitoring 85
Parameters Menu 88
Group 3.1: Motor Settings 88
Group 3.2: Start/Stop Setup 90
Group 3.3: References 91
Group 3.4: Ramps and Brakes Setup 94
Group 3.5: I/O Configuration 95
Group 3.6: Fieldbus Data 102
Group 3.7: Prohibit Frequencies 104
Group 3.8 Supervisions 104
Group 3.9: Protections 105
Group 3.10: Automatic Reset 108
Group 3.11: Application Settings 109
Group 3.12: Timer Functions 110
Group 3.13: PID Controller 112
Group 3.14: External PID Controller 120
Group 3.15: Multi-pump 123
Group 3.16: Maintenance Counters 125
Group 3.17: Fire Mode 126
Group 3.18: Motor Preheat Parameters 127
Group 3.19: Drive Customizer 127
Group 3.21: Pump Control 127
Group 3.23: Advanced Harmonic Filter 130
Group 3.24: Condition-based Monitoring 130
Diagnostics Menu 135
Faults 135
Uses of the Active Faults Submenu 135
Reset Faults 135
Resetting Faults with the [BACK/RESET] Button 135
Resetting Faults with a Parameter on the Graphical Display 135
Resetting Faults with a Parameter on the Text Display 135
Uses of the Fault History 136
AB298035655957en-000201/DPD01083 | 5Danfoss A/S © 2023.08
Contents
VACON® 100 FLOW
Application Guide